Round Tube Roll Set for Manual 3-Roll (Large Radius) Bender (28.0 mm OD) 180 degrees This die fits the Portabender

This die fits the Portabender Tube and Pipe Bender for bending 1" by 1" square tubing at a centerline radius of 3-1/2" with a maximum degree of bend of 90 degrees after springback

Follow Bar Support Bar

repeatable notches in seconds

after springback

If your parts are simple 2D parts (parts that lay flat when completed) then EZ will most likely do the trick

Round Tube Roll Set for Manual 3-Roll (Large Radius) Bender (28.0 mm OD) 180 degrees This die fits the PortabenderSpecs Outside Diameter of the Tubing (OD): 28. 0 mm Maximum Wall Thickness: 0. 120" (3. 0 mm) Minimum Inside Radius: Approximately 12 (304. 8 mm), depending on the type, grade, wall thickness, and quality of the material Includes 1 x Keyed Center Roll 2 x Secondary Rolls Resources Tube and Pipe Bending Basics What Am I Bending: The Differences Betweeen Tube, Pipe, and More Lead Time Lead times vary by product. Many orders can ship out within a few