Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for cross tension testing of resistance spot and embossed projection welds Ingestion-build-89079 i) assumptions for the selection

i) assumptions for the selection of dose-critical parameter values

9 Requirements for non load-bearing boards for use in humid conditions (Type P3)

Therefore this document reflects the situation at the date of June 2014

over further lifecycles

It specifically supports digital certificate enabled communication across borders

Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for cross tension testing of resistance spot and embossed projection welds Ingestion-build-89079 i) assumptions for the selection1 Scope This International Standard specifies specimen dimensions and a testing procedure for the cross tension testing of spot and projection welds in overlapping sheets in any metallic material of thickness 0,5 mm to 3 mm, where the welds have a maximum diameter of 7t (where t is the sheet thickness in mm). The object of cross tension testing is to determine the tensile force that the test specimen can sustain.